Filter
Top Products
C A U T I O N !! :BE EXTREMELY CAREFUL NOT TO TOUCH ANY HIGH POWER LINES
DURING INSTALLATION OF THE VARIOUS SENSORS!!!
The wind direction and speed sensor is normally mounted on television type antenna masts. For
best results the wind · ·
sensor should be mounted twenty feet above the roof of the building. The higher the installation, the
more accurate the readings. The wind direction sensor is calibrated at the factory and should be
installed with the wind sensor arm pointed to the North. If you are unable to point the wind sensor
arm to the North you can change the wind direction offset in the OneSix server INI file. Plug the
wind sensor RJ11 connector into the mast mounted junction box (if present).
The TWI Lightning Sensor must be mounted at the top of a grounded mast. The taller the mast and
the better the earth grounding the further away lightning can be detected. A detection range of over
200 miles can be achieved depending on the installation.
Mount the Lighting Sensor one inch below and 180 degrees away from the wind sensor (refer to
figure A) in order to gain the maximum distance between the two sensors. The top of the Lightning
sensor must not be below any part of the grounded mast, doing so will shield the sensor from
detecting lightning from that direction
The outside temperature/humidity pagoda should be mounted about two feet under the wind sensor.
Again we suggest a twenty-foot mast for commercial installations to overcome the artificially high
readings generated by a hot roof. Plug the temperature/humidity pagoda cable into RJ11 connector
1-Wire Weather Station
Texas Weather Instruments, Inc. 1-Wire Weather Station
in the junction box.