Filter
Top Products
www.tanaka-usa.com 5 custsvc@tanaka-ism.com
Owner’s Manual
TPE-2501,TPE-2510,TPE-270PF/PN,TPE-250PF
Installation of blade guard (Fig. 1-7)
1) Install blade guard (1) on gear case (4) temporarily by clamping with guard brackets (2)
and screws (3). Then tighten as needed.
2) Line up the slot of guard bracket (2) with the same of gear case (4), then tighten screws
(3) securely. (Fig. 1-7B)
Installation of blade (Fig. 1-8)
1) Before installation of blade, take off left hand
threaded fixing nut (1), cutter holder cap (2) from the
blade shaft.
2) Install blade (3) on the shaft and then replace the
cutter holder cap and fixing nut in order.
NOTE!
When installing cutter holder cap (2), be sure to set
concave side facing blade.
3) Insert the locking bar (4) into the hole of the cutter
holder (5) and gear case by lining up each hole.
4) Tighten the fixing nut securely (clockwise to
loosen/counter-clockwise to tighten).
Installation of wheel (Fig. 1-7C)
1) Installation the wheel as the illustration.
2) After installation, check if the wheel turns
smoothly.