www.tanakapowerequipment.com 14 custsvc@tanaka-ism.com
Owner’s Manual
ECV-4501
Guide bar (Fig. 3-5)
Before using the machine, clean the groove and oiler port (1) in the bar with the special gauge offered as an optional
accessory.
Oiler port (Fig. 3-4)
Clean the chain Oiler port (1)
whenever possible.
Side case (Fig. 3-6)
Always keep the side case and drive area clean of saw dust and debris.
Periodically apply oil or grease to this area to protect from corrosion as some trees contain high levels of acid.
Fuel filter (Fig. 3-7)
Remove the fuel filter from the fuel tank and thoroughly
wash it in solvent. After that, push the filter into the tank
NOTE!
If the filter is hard due to dust and dirt, replace it.
Cleaning the muffler (Fig. 3-10)
Remove the muffler and spark arrestor (if so equipped), and clean out any excess carbon from the exhaust port or
muffler inlet every 100 hours of operation.
For long-term storage
Drain all fuel from the fuel tank. Start and let engine run until it stops. Repair any damage which has resulted from
use. Clean the unit with a clean rag, or the use of high pressure air hose. Put a few drops of two-cycle engine oil into
the cylinder through the spark plug hole, and spin the engine over several times to distribute oil. Cover the unit and
store it in a dry area.
Chain oil filter (Fig. 3-8)
Remove the oil filter and thoroughly wash
it in solvent
Cleaning the cylinder fins (Fig. 3-9)
When wood chips are caught between cylinder fins (1),
the engine may overheat, resulting in lower output. To
avoid this, always keep cylinder fins and fan case clean.
Every 100 Operating hours, or once a year (more often if
conditions require), clean fins and external surfaces of
engine of dust, dirt and oil deposits which can contribute
to improper cooling.