Filter
Top Products
www.tanakapowerequipment.com 19 custsvc@tanaka-ism.com
Owner’s Manual
TCS-3401
IMPORTANT NOTICE
THIS INFORMATION IS FOR THE US AND CANADIAN MARKETS ONLY.
Only use replacement bars and chains specified by the manufacturer other equivalent.(See the chart below)
Bar & Chain USA and Bar & Chain CANADA
LOW KICKBACK BAR AND CHAIN COMBINATIONS FOR USA
Low-Kickback saw chain is chain which has met the kickback performance requirements of
ANSI Bl 75.1 -199 1. (American National Standard for Power Tools-Gasoline Powered Chain Saws-Safety
Requirements) when tested on the representative sample of chain saws below 3.8 c.i.d. specified in ANSI
B175.1-1991.
WARNING!
Use of other non-listed Bar/Chain combinations may increase kickback forces and increase the risk of kickback
injury.
To reduce the possibility of kickback, it is important to use the correct bar and chain combinations. Following is
a list of recommended combinations for Tanaka saws, TCS-3401. These powerhead, bar and chain
combinations have been investigated in accordance with the ANSI Bl 75.1-1991 standards.
MODEL NUMBER BAR NUMBER LENGTH-TYPE CHAIN NUMBER
TCS-3401 120SDEA041 12”-DG 91VG045X
140SDEA041 14”-DG 91VG052X
DG-DOUBLE GUARDTM(is registered trademark of OMARK industries) ... Reversible reduced kickback-bar.