Filter
Top Products
BACKING UP
•
Disengage blade.
•
Check safety behind you.
•
Move transaxle into “REVERSE” position.
•
Activate “GROUND CONTROL” bail.
TRANSPORTING
•
Disengage blade.
•
Shut off engine and remove keys.
•
Using 3 persons to lift cutter is recommended.
•
Secure in place while unit is being transported.
•
Unit should be left in low gear to avoid any slight rolling.
SUGGESTED PRACTICES
•
Always operate engine at full throttle when cutting to assure the best cutting
performance and proper discharge of material.
•
If grass is wet, allow it to dry out. Wet grass clumps will collect on the bottom of
the deck.
•
Go Slow when cutting dense areas. Some dense areas may need to be gone over
twice. Better results occur if the second cut is 90 degrees to the first cut.
BLADE IDLER(2455) & BRAKE CONFIGURATION(2462)