Filter
Top Products
7
4a
IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME
Where the Posts and the Bottom Support Channels join, attach Angle Support Bars.
The illustrations below indicate Close-up illustrations show the proper assembly
procedure for each location.
Where One Angle Support Bar attach to the Post use the ½” Sheet Metal Screws.
Where Two Angle Support Bars attach to the Post use the 1” Sheet Metal Screw.
Where the Angle Support Bars attach to the Bottom Support Channels use the ½” Truss
Head Screws and Hex Nuts.
Note carefully in the Close-ups the position of the slots in the Angle Support Bars.
Again, only hand tighten screws at this time.
POST FOR LADDER
ATTACHES ON
EITHER SIDE
CLOSE-UP
#7
CLOSE-UP
#7
CLOSE-UP #7
CLOSE-UP #7
CLOSE-UP
#8
CLOSE-UP #7 CLOSE-UP #7
POOL
POST FOR LADDER
ATTACHES ON
EITHER SIDE
CLOSE-UP
#7
CLOSE-UP
#7
CLOSE-UP #7
CLOSE-UP #7
CLOSE-UP
#8
CLOSE-UP #7 CLOSE-UP #7
POOL
15’ END DECK
&
18’ END DECK
12’ END DECK
1” SHEET
METAL SCREW
1/4” x 20
HEX NUT
1/2” SHEET
METAL SCREW
1/4” x 20 x 1/2”
TRUSS HEAD SCREW
ANGLE
SUPPORT
BAR
BOTTOM
SUPPORT
CHANNEL
BOTTOM
OF POST
CLOSE UP #7
BOTTOM
OF POST
ANGLE
SUPPORT
BAR
BOTTOM
SUPPORT
CHANNEL
1” SHEET METAL
SCREW
CLOSE UP #8