Stiga VE32 Lawn Mower User Manual


 
29
ENGLISH
EN
5.3 During use
Connect the machine using an extension lead to a
230 VAC electric socket. See “4.1.1 Electric sock-
et and relieving loop”. The electric socket must
have a 10 A fuse.
Set the desired cutting depth and start the machine.
Start working on the lawn as close to the mains
electric socket as possible in order to minimise the
risk of running over the cable. The cable must not
be run over under any circumstances.
Never stretch the cable; it should remain in a loose
loop at the side of the machine.
5.4 After use
The machine must not be rinsed with
water. This will damage the machine’s
electrical components and can produce
fatal electric shocks.
Stop the machine and disconnect the connection
cable.
Clean the machine with a soft brush and a moist
cloth.
Store the machine in a cool, dry location.
6 MAINTENANCE
The machine must always be disconnect-
ed from power when carrying out mainte-
nance or repairs. Risk of crushing injuries
and fatal electric shocks.
6.1 Regular maintenance
The machine requires no regular maintenance oth-
er than cleaning, as described above.
6.2 Adjusting drive belt
1. Remove the belt cover and the motor casing by
unscrewing the 5 screws in fig. 5.
2. Remove the inner motor casing.
3. Undo the motor’s adjustment screws. See fig. 6.
4. Push the motor forwards until the belt is cor-
rectly tensioned. Check that the engine is ten-
sioned equally on both sides.
5. Tighten the motor’s adjustment screws.
6. Reassemble the casings and covers. See fig. 5.
7 RECYCLING
Waste management in accordance with
the WEEE Directive (2002/96/EC)
Take care of the environment!
Do not discard with household
waste!
This product contains electrical
and electronic components that
must be recycled.
Hand the product in for recycling
at the indicated location, e.g. the
municipal recycling station.