Filter
Top Products
7
ENGLISH
GB
SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that
are required during use.
The symbols mean:
Warning! Read the Instruction Book and
Safety Manual before using the machine.
Warning! Keep onlookers away. Beware
of objects being flung out.
Warning! Keep hands and feet clear of the
cutting deck when the machine is running.
Warning! Before starting any repair work,
remove the spark plug cable from the
spark plug.
IMPORTANT
Certain sections apply to only one or a few of the
models. Where this is the case, the name of the
model appears at the start of the section.
Certain models do not have throttle control. The
engine’s speed is set for optimal function and min-
imal exhaust emissions.
INSTALLATION
HANDLE/BUMPER
(PRO 51 S)
Press in the end plugs in the openings on the han-
dle. Place the handle on the cover so that the holes
in the handle are aligned with the holes in the cov-
er. Thread through the carriage bolts from under-
neath and secure with the locking nuts U.Presson
the nut caps V (fig 28).
HANDLE, LOWER PART
(PRO 48/PRO 51S)
Fold back and screw tight the lower part of the
handle using the screws A (fig. 1).
HANDLE, UPPER PART
Fit the upper part of the handlebar (fig. 2). The
height of the handlebar above the ground can be
adjusted within certain limits since the lower part
is provided with slotted holes at the rear (fig. 3).
If necessary the upper part can be turned to one
side to facilitate mowing close up to walls (fig. 4).
CABLE HOLDERS
Secure the cables in the cable holders (fig. 5):
D: Start/Stop cable + Honda: Throttle cable
E: Multiclip 51S/PRO 51S: Clutch cable
USING THE MOWER
BEFORE STARTING
FILL THE CRANKCASE WITH OIL
The lawnmower is delivered without
any oil in the engine crankcase. The
crankcase must be filled with oil before
the engine is started for the first time.
Remove the oil dipstick (fig. 6-9). Fill the engine’s
crankcase with 0.55 litres of good quality oil (serv-
iceclassSE,SForSG).UseSAE30orSAE10W-
30 oil.
Fill until the oil reaches the “FULL/MAX” mark
on the dipstick. Do not overfill.
CHECK THE OIL LEVEL
Check before using the machine that the oil level is
between ‘FULL/MAX’ and ‘ADD/MIN’ on the
dipstick. The mower should stand level.
Remove and wipe off the dipstick (fig. 6-9). Slide it
down completely and tighten it. Unscrew and pull it
up again. Read off the oil level. If the oil level is
low, fill with oil up to the ‘FULL/MAX’ mark.
FILL UP THE PETROL TANK
Fill with petrol before starting the en-
gine. Never remove the filler cap or fill
with petrol while the engine is running
or still warm.
Never completely fill the petrol tank. Al-
low a little room for the petrol to expand
if necessary.