Filter
Top Products
4
ENGLISH
GB
GENERAL
Your garden shredder is a high-quality, efficient
machine.
Please read the following instructions carefully to
ensure a long life of your garden shredder.
Do not operate machine before having
read the operating instructions, under-
stood all the notes and assembly the ma-
chine as described here.
PROPER USE
The garden shredders are suitable for private use in
gardens and allotments.
Regarded as garden shredders for private gardens
and allotments are those units which are not em-
ployed in public grounds, parks, sports grounds,
andinagricultureandforestry.
SAFETY INSTRUCTIONS
Repairs on electrical parts of the ma-
chine and on the safety cut-out must be
done by the producer or by a company
designated by the producer.
Please read the following safety instruc-
tions carefully.
• Within his area of work the operator will be re-
sponsible to third parties.
• The machine may not be used by operators un-
der the age of 16.
• Keepchildrenawayformmachine.
• Wear protective goggles, gloves and noise pro-
tection while working with the machine.
• The connecting lead to DIN 57 282 (H 07 RN-F)
should be equipped with a rubber plug. The lead
section should be a minimum of 3 x 1,5 mm².
• Never use faulty connecting lines.
• Connect the machine using a fault current pro-
tection switch.
• Always switch off motor before maintenance
and cleaning of shredder. Remove mains plug
from socket (also during transport and when
leaving machine unattended).
• Do not operate without the funnel.
• Faulty or damaged parts in the device must be
replaced immediately.
• Never reach into the filling or ejection opening
when the machine is running.
• Do not spray machine with water (this is haz-
ardous due to live components).
• Wear safety gloves during assembly and clean-
ing work.
• Never modify the machine or parts thereof.
• Only use the machine for the purposes listed un-
der Section “Chopping”.
• Do not leave the machine standing in the rain or
use when raining. Store the machine in a dry
place.
ASSEMBLY
See pages 4 - 5.
Use the enclosed disposable screws
(M5 x 16) to fit the funnel (a) to the pre-
assembled machine (b). Otherwise no li-
ability will be assumed!
START-UP
Check that the machine is completely and correctly
assembled.
To avoid toppling, place the chopper on a firm hor-
izontal surface.
Connect the machine to an appropriate and correct-
ly wired electric socket.
Only use extension leads with sufficient diameters:
- cable up to 25 metres: diameter at least 1,5
mm².
- cable over 25 metres: diameter at least 2,5 mm².
Fuse protection:
- for model 2000: 16 A inert
Before using the shredder, make sure each time
that:
- there are no faulty connections (tears, cuts, etc.)
-allscrewsaretight.