9
ENGLISH
GB
GRASS COLLECTOR (fig. 9)
Fabric collector bin: Pull the fabric collector bag
over the steel frame and snap the bag on the plastic
cover.
Plastic collector bin: Snap the two halves together
and then the upper part.
Open the cover on the machine and hook the grass
collector onto the chassis.
Note! The lawn mower can be used without the
grass collector. The grass will then collect in a
bead behind the machine.
USING THE MOWER
CUTTING HEIGHT (fig. 10)
Depending on the model, the cutting height is ad-
justed as follows:
I. Fasten the wheels in one of the four possible po-
sitions.
II. Set the height adjustment lever to the desired
position.
Note! The same cutting height should be set on all
four wheels.
CONNECTION (fig. 11)
Only use an extension cable approved for outdoor
use. If uncertain please contact your dealer.
To increase safety the lawn mower should be con-
nected to an earth-fault breaker.
Support the extension cable in the cable support on
the steering.
START/STOP (fig. 12)
Start the mower on flat, solid ground. Do not start
in long grass. Press on the steering so that the front
wheels lift slightly from the ground to reduce grass
resistance.
Starting the motor:
1. Press the button
2. Pull the handle towards the steering.
Stopping the motor: Release the handle.
CUTTING (fig. 13)
Always cut away from the cable.
Empty the grass collector in good time so that the
grass deflector does not get blocked and reduce
grass collection capacity.
To avoid overloading the motor, do not push the
mower too quickly in long grass.
MAINTENANCE
CHANGING BLADES (fig. 14)
Always pull out the plug before carrying
out maintenance, cleaning or other ac-
tions on the machine.
Wear protective gloves. Loosen the blade bolts us-
ing a 26 mm spanner. Fit a new blade. Tightening
torque 22 Nm.
Always use genuine spare parts.
CLEANING AND STORAGE (fig. 15)
Always wipe or brush off the mower after use.
The cold air intake around the motor casing should
always be kept free from grass and dirt so that the
motor does not overheat.
The underside of the chassis can be scraped clean.
Never rinse with water.
The mower should be stored in the dry.