Stiga 8211-0072-80 Lawn Mower User Manual


 
24
ENGLISH
EN
Use these identification terms during all contact
with service workshops and when purchasing
spare parts.
As soon as possible after acquiring the machine,
the above number should be written in on the last
page of this publication.
7 ENVIRONMENT
For environmental reasons, we recommend that
particular attention is given to the following
points:
Always use Alkylate petrol (“Environmental
petrol“).
Always use a funnel and/or a petrol can with
overfill protection to avoid spillage when filling
with petrol.
Do not fill the petrol tank right to the top.
Do not fill too much engine and/or transmission
oil (see user instructions for the correct
amount).
Collect up all oil during oil changes. Do not
spill any. Hand in the oil to a recycling station.
Do not discard replaced oil filters with normal
rubbish. Hand them in to a recycling station.
Do not discard replaced lead batteries with
normal rubbish. Hand in to a battery collection
point for recycling.
Replace the silencer if it is broken. Always use
original spare parts when carrying out repairs.
If the machine was originally equipped with a
catalytic converter and this is broken, a new
catalytic converter must be installed after
removing the old one.
Always get a specialist to adjust the carburettor
if necessary.
Clean the air filter according to the instructions
given (see user instructions).
8 INSURE YOUR RIDE-ON
LAWNMOWER
Check the insurance for your new ride-on
lawnmower. Contact your insurance company.
You ought to have fully comprehensive insurance
for traffic, fire, damage and theft.
9 GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
You must read these instructions and
the accompanying pamphlet “SAFETY
INSTRUCTIONS” carefully, before the
assembly begin.
10 ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures in this instruction
have been carried out..
10.1Assembly components
Components that are to be used at assembly are in-
cluded in the delivery. See fig. 1.
Supplied in bag:
A plastic bag containing components, which are to
be used at assembly, are included in the delivery.
See fig. 1. The bag contains:
Pos No. Designation Dimension
A 1 Pin 6 x 36
B 1 Shim washer 16 x 38 x 0.5
C 1 Shim washer 16 x 38 x 1.0
D 2 Ignition key
F 2 Screw for battery
G 2 Nut for battery
H2 Nut M8
I 1 Towing plate
J 2 Screw 8 x 20
Q 2 Screw M10 x 35
R2Nut M10
Supplied installed on the front axles:
Pos No. Designation
K 2 Lock pin
L2Washer
Secure to the implement lifter:
Pos No. Designation
M 2 Deck mount