Filter
Top Products
62
ENGLISH
EN
4.2 Bleeding
The engine’s fuel system must be bled in the fol-
lowing instances:
• If the fuel tank has been run dry and air has been
drawn into the fuel system.
• After replacing the filter.
Bleed as follows:
1. Fill the tank with fuel.
2. Pump using the hand pump (10:Y) until all air
has been pumped out.
4.3 Level check, engine oil
On delivery, the crankcase is filled with SAE 10W-
40 oil.
Always check the oil level before use to ensure it
is correct. The machine should be standing on
level ground.
Check the oil level as follows:
1. Wipe around the dipstick.
2. Unscrew and pull the dipstick up.
3. Wipe the dipstick.
4. Slide the dipstick down completely and pull up
again.
5. Read off the oil level. The oil level should be at
the “Max” mark as illustrated in fig. 11.
If the oil level is below the “Max” mark in fig. 11,
fill with oil as follows:
1. Unscrew the oil filler cap (11:C).
2. Fill with the necessary amount of oil. Applica-
ble oil types, see “5.4”.
3. Check the level as above.
4. When the level is correct, reinstall the oil filler
cap and tighten.
The oil level must never exceed the “Max” mark as
illustrated in fig. 11. This can cause the engine to
overheat. Drain the oil to the correct level if the oil
level exceeds the “Max” mark.
4.4 Level check, transmission oil
See 5.8.1.
4.5 Safety checks
Check that the results of the safety checks below
are achieved when testing the machine in question.
The safety checks must always be car-
ried out every time before use.
If any of the results below is not
achieved, the machine must not be
used! Take the machine to a service
workshop for repair.
4.5.1 General safety check
4.5.2 Electrical safety check
The operation of the safety system
should always be checked every time
before use.
4.6 Start
1. Do not keep your foot on the drive pedal.
2. Put the throttle control at full throttle.
3. Depress the brake pedal fully.
4. Turn the ignition key and start the engine. The
engine does not need to be preheated.
Object Result
Fuel lines and con-
nections.
No leaks.
Electrical cables. All insulation intact.
No mechanical damage.
Exhaust system. No leaks at connections.
All screws tightened.
Oil lines No leaks. No damage.
Drive the machine
forwards/back-
wards and release
the driving-service
brake pedal.
The machine will stop.
Test driving No abnormal vibrations.
No abnormal sound.
Status Action Result
The clutch-brake
pedal is not
depressed.
The power take-off
is not activated.
Try to start. The engine
will not start.
The clutch-brake
pedal is depressed.
The power take-off
is activated.
The driver gets up
from the seat.
The engine
will not start.
Engine running.
The power take-off
is activated.
The driver gets up
from the seat.
The power
take-off will
be disen-
gaged.
Status Action Result
Cruise control acti-
vated.(4WD)
The driver gets up
from the seat.
The cruise
control will
be disen-
gaged.
Cruise control acti-
vated. (4WD)
The clutch-brake
pedal is depressed.
The cruise
control will
be disen-
gaged.