Filter
Top Products
16
17
13 Regulator is damaged Replace.
14 Motoroverloadprotection
switch has tripped
Refer to Motor Overload Protection under Features.
If motor overload protection trips frequently, contact a
B
O
STITCH factory service center
or a B
O
STITCH authorized service center.
15 Tank pressure exceeds
Pressure Switch (H) cut-in
pressure
Motorwillstartautomaticallywhentankpressuredrops
below cut-in pressure of Pressure Switch (H).
16 Extension cord is wrong
length or gauge
Check for proper gauge wire and cord length. Refer to the
Extension Cords paragraph in the Installation section.
17 Loose electrical
connections
Contact a B
O
STITCH factory service center or a B
O
STITCH
authorized service center.
18 Possible defective motor Contact a B
O
STITCH factory service center or a B
O
STITCH
authorized service center.
19 Paint spray on internal
motor parts
Contact a B
O
STITCH factory service center or a B
O
STITCH
authorized service center. Do not operate the compressor in
the paint spray area. See flammable vapor warning.
20 Fuse blown, circuit
breaker tripped
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for our particular
branch circuit.
2. Check for proper fuse. You should use a time delay fuse.
3. Checkforlowvoltageconditionsand/orproperextensioncord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
21 Worn Belt Contact a B
O
STITCH factory service center or a B
O
STITCH
authorized service center.
22 Restricted air intake filter Clean or replace air intake filter. Do not operate the air
compressor with the filter removed. Refer to the Air Filter
(J) paragraphintheMaintenancesection.