Filter
Top Products
XR 425
9
STEP 2: CONSOLE MAST ASSEMBLY
1. Install the Console Mast Cover (31) onto the console mast (2). Make sure the plastic cover is in
the correct orientation.
2. Feed the computer cable (44) though the bottom of the console mast (2) and out though the
opening at the top.
3. Install the console mast (2) into the receiving tube (make sure not to pinch the wire cable as
damage to the electronics could occur) of the Main Frame with the 6pcs of 5/16 Hex Head
Screws (68), 4pcs of 5/16 Flat Washers (76) on the sides and 2pcs of 5/16 Curved Washers
(83) on the front by using the 12/14mm Wrench (112).
4. Remove the white styrofoam pad (factory installed to prevent bolts from being accidentally
dropped into the Bike).
5. Install the Handle Bar (3) onto the Console Mast (2) with the 2pcs of 5/16 x 15mm Hex Head
Bolts (68), 2pcs of 5/16 x 20 x 1.5T Flat Washers (83) and 2pcs of 8m/m x1.5T Split Washers
(82) by using the 12/14mm Wrench (112).