Filter
Top Products
PLACING INSIDE PATIO TABLE UMBRELLA HOLE
If desired, the Soleus Air Electric Patio Heater can be placed in a standard 2” umbrella hole found in many
patio tables. This heater may not fit non-standard smaller umbrella holes found on some tables.
Before placing the unit inside the umbrella hole in patio table, unplug the unit and let it cool completely.
• First, unfasten the power cord under the base so that it is loose and able to be removed. Now, remove the
middle pole (E) to the top pole (D) . Once the middle pole (E) is apart from the top pole (D), remove the
power cord from inside the base.
• Next, place the base and base pole directly under the umbrella hole in your patio table.
• Now, place the rest of the assembled heater through the umbrella hole in the patio table, place the power
cord through the middle pole (E) and base pole (F) underneath the umbrella hole, and attach the top pole
(D) to the middle (E) pole.
• Before plugging the heater in for use, align and fasten the power cord with the cutout and secure using the
fasteners on the bottom of the base.
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate the
heater when it is in the upright position and the base is attached. Refer to the diagram below.
The HP1-15-50 Electric Patio Heater is equipped with three heat settings; Low, Medium, and High.
• To operate the heater on low, press the red switch on the right. This switch will have a single white dot
near the top. Once the low switch is pressed, the smaller bottom heating element will glow and radiate
heat.
• To operate the heater on medium, press the red switch on the left. This switch will have two white dots
near the top. Once the medium switch is pressed, the larger top heating element will glow and radiate heat.
• To operate the heater on high, press both the low and medium red switches. This will cause both the bot-
tom and top heating elements to glow and radiate heat.
HEATER
CONTROLS
8