Filter
Top Products
Assembly
(See page 4 for location of parts.)
Fitting the guard and guide wheel
1. Align the 3 screw holes in the
guard with the screw holes in
the base of the unit.
2. Attach the edging wheel to
your trimmer by Fastening the
screw. (*Note, the wheel is
attached for edge cutting only.)
3. Attach the ower guard
to the motor housing.
NOTE:
4. Attach shoulder strap to shoulder strap bolt.
Adjusting the telescopic
handle
1. Loosen the telescopic shaft
adjustment knob, adjust the
shaft to a comfortable height.
Make sure to tighten the
knob once the desired length
is suitable.
Fitting the secondary handle
To adjust the secondary handle
press in the secondary handle
buttons and rotate the handle
to the desired position then
release the buttons to lock it
into place.
To remove or install battery
pack
Locate latches on side of battery pack
and depress both sides to release
battery pack from your grass trimmer.
Remove battery pack from your grass
trimmer. After recharging the battery
pack insert it into the battery slot of
the trimmer..
Vertical head adjustment
The head can be adjusted so that it at
horizontal with the ground, this feature
helps you get access to areas such as
under bushes and garden furniture.
The head can be lowered by pressing
the head adjustment button (9) and
set to the desired angle.
Before starting
The battery pack for this tool has been shipped in a low
charge condition. You should charge the battery pack
fully before use.
Before use, follow these steps to check that the tool is working
properly and the length of the line is correct:
1. Your trigger switch is locked OFF to prevent accidental
starting. Depress lock off button (4) then the ON/OFF
trigger switch (3) and release lock off button (4), your
switch is now ON. To switch OFF just release the ON/
OFF trigger switch (3).
2. Examine the general condition of the tool. Inspect
the guard, switch, cord set. Check for loose screws,
misalignment, binding of moving parts, improper
mounting, broken parts and any other condition that
may affect its safe operation. If abnormal noise or
vibration occurs during operation, turn the line trimmer
off immediately and have the problem corrected.
3. Ensure that you are on a at surface and have secure
footing.
4. Check that the line touches or extends beyond the
edge of the guard.
Attach the
Flower Guard
in place here
5