Filter
Top Products
Adjust the Cutting Height (Fig. 8)
1. Simply depress the lever towards the wheel and
move to desired position. This sets all wheels to
the same position.
2. To raise the height, pull the height adjustment lever
from the current stop position towards the back of
the mower.
3. To lower the height, pull the height adjustment lever
from the current stop position towards the front of
the mower.
7-Position Height Adjustment:
1. 1-3/4 in. 5. 3 in.
2. 2 in. 6. 3-1/4 in.
3. 2-1/4 in. 7. 3-3/4 in.
4. 2-1/2 in.
Charging Procedure
NOTE: The battery can be charged in or out of the mower.
The charger that is supplied with this mower is a specially
designed 2-stage charger.
Step 1: The red light will light up during the recharge cycle.
Step 2: The green light will light up when the battery is fully
charged.
1. Plug the charger connector into the jack on
the battery.
2. Insert the 120 V plug from the charger into the
electrical outlet.
3. The red light on the charger should come on, which
indicates that the charger is working and the battery
is being charged. The red light will go out and the
green light will come on when the battery is
completely charged (it takes approximately 15
hours to charge a fully discharged battery).
m WARNING: Do not store battery in temperatures lower
than 32°F (0°C).
7
R
Fig. 8
High
Low
Installing the Battery
1. Level two rails and push battery down to limit chute.
1. Slide the battery backward to unlock.
1. Plug charger output into battery input.
2. Plug charger into wall receptacle outlet.
2. Slide the battery forward to lock into position.
2. Pull out the battery pack from the limit chute.
Removing the Battery
Charging the Battery
R
R
R
R