Snapper S200KAV2561, S200XK2761 Lawn Mower User Manual


 
44
www.SnapperPro.com
ENGINE:
25 HP Kawasaki
Make Kawasaki
Model FH721V
Horsepower 25 @ 3600 rpm
Displacement 41.2 Cu. in (675 cc)
Electrical System 12 Volt, 13 amp. Alternator, Battery: 340 CCA
Oil Capacity 2.0 US qt. ( 1.9 L) w/ Filter
27 HP Kohler
Make Kohler
Model CV740S
Horsepower 27 @ 3600 rpm
Displacement 44.24 Cu. in (725 cc)
Electrical System 12 Volt, 16 amp. Alternator, Battery: 340 CCA
Oil Capacity 2.1 US qt.. (2.0 L) w/ Filter
CHASSIS:
Fuel Tank Capacity: 12 Gallons (45.4 L)
Rear Wheels Tire Size: 24 x 12.00 -12
Inflation Pressure: 15 psi (1,03 bar)
Front Wheels Tire Size: 13 x 6.50 - 6
Inflation Pressure: 25 psi (1,72 bar)
TRANSMISSIONS:
HydroGear PG-3H / HGM-12E 3131
Type Pump and Wheel Motor
Hydraulic Fluid SAE 20W-50 motor oil
Speeds Forward: 0-10 MPH (0-16.09 km/h)
@ 3400 rpm Reverse: 0-5 MPH (0-8.05 km/h)
Continuous Torque 222 ft. lbs. (301 N.m.)
Output
Maximum Weight 750 lbs. (340 Kg)
on Axle
DIMENSIONS:
Overall Length 79” (201 cm)
Overall Width 62” (157 cm)
Height 68” (173 cm)
Weight (apx..) 1175 lbs. (534 kg)
NOTE: Specifications are correct at time of printing and are subject to change without notice.
Specifications
Engine Power Rating Information
The gross power rating labels for individual gas engine models meet or exceed SAE (Society of Automotive Engineers) code
J1940 (Small Engine Power & Torque Rating Procedure) and rating performance has been obtained and corrected in
accordance with SAE J1995 (Revision 2002-05). Actual gross engine power may be lower and is affected by, but not limited
to, ambient operating conditions and engine to engine variability. Given both the wide array of products on which engines are
placed, and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the
rated gross power when used in a given piece of power equipment (actual “on-site” or net power). This difference is due to a
variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump,
etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine to engine variability.
Specifications
Specifications