Filter
Top Products
34
www.SnapperPro.com
Deck Rod Timing Adjustment
1. Park machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. To check the lift rod timing, measure and record the
distance between the lift pivots and the rod pivots.
Repeat for other side of unit. See Figure 37.
3. If the measurements for the rods are equal, no further
adjustment is required. If the measurements are NOT
equal (greater than 1/8” (3,17mm) difference),
adjustment is required, continue with Step 5.
4. Lock the deck lift pedal in the 5” (12,7cm) position.
Remove the cutting height adjustment pin and lower the
mower deck.
5. To ensure that the deck is in the lowest position, push
the pedal by hand towards the rear of the unit and install
the height adjustment pin in the 3” (7.6cm) position to
hold in place.
6. Block up the mower deck until all hanger chains are
slack. Refer to Figure 39.
7. See Figure 38. To adjust the lift rod, loosen the jam nut
on the front clevis then remove the 1/2” clevis pin
fastening the clevis the the lift pivot arm. Turn the clevis
clockwise to shorten the distance between the rod pivots
or counterclockwise to lengthen the distance between
the rod pivots. Reinstall the clevis on the lift pivot arm
and secure with the 1/2” clevis pin previously removed.
Tighten the jam nut against the clevis.
8. Remove blocks from under the mower deck.
9. Remove the the cutting height adjustment pin from in
front of the deck lift pedal arm. Lift mower deck and
reinstall adjustment pin in desired mowing height.
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift rod
timing must be checked and/or adjusted.
1. Park machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. Lock the deck lift pedal in the 5” (12,7cm) position.
Place the deck height adjustment pin in the 4" position
and lower deck the lift pedal until the arm contacts the
pin.
3. Place 2 x 4 blocks under each corner of the mower deck
with the 3-1/2” sides being vertical. Place a 1/4”
(0,64cm) thick spacer on top of the rear 2 x 4 blocks.
See Figure 36.
6. Adjust the front eyebolts until the chains are tight and
the deck is still resting on the 2 x 4’s. Tighten jam nuts.
See Figure 40.
7. Loosen the nuts and allow the rear of the deck to rest on
the 2 x 4’s and 1/4” spacers. Slide the chains down in
the slots until the chains are tight and tighten the nuts.
See Figure 40.
8. Remove all 2 x 4 blocks and spacers from under the
mower deck.
Figure 37. Check Lift Rod Timing
Figure 38. Adjust Lift Rod Timing
Figure 39. 2 x 4 Locations
Figure 40. Hanger Chain Adjustment
Regular Maintenance
Maintenance