Filter
Top Products
8
Section 2 - OPERATING INSTRUCTIONS
2.4 ENGINE STARTING PROCEDURE
Step 3: Briggs Engine - Move ENGINE SPEED
CONTROL to FAST position and turn FUEL VALVE to
ON position. See Figure 6.
FIGURE 6
Step 3: Honda Engine - Move ENGINE SPEED
CONTROL to FAST (rabbit) position and move FUEL
VALVE forward to ON position. See Figure 6A. ENGINE
KILL SWITCH must be in ON position. See Figure 5A.
FIGURE 6A
Step 4: Move to the right side of Tiller and place your
foot on top of the right wheel (See starting procedure
decal located on top of the tine cover), hold handle bar,
then pull the ROPE STARTER HANDLE in smooth,
steady motion until the engine starts. To prolong the life
of the rope, guide the handle back to the engine rather
than allowing it to snap back.
Step 5: Briggs Engine - Allow a brief warm-up period,
then move the CHOKE CONTROL rearward to RUN
POSITION and the ENGINE SPEED CONTROL to the
desired speed setting. Refer to the tilling procedure
section.
Step 5: Honda Engine - Allow a brief warm-up period,
then move the CHOKE CONTROL forward to the OFF
POSITION. Move the ENGINE SPEED CONTROL to the
desired speed setting. Refer to the tilling procedure
section.
Step 6: Briggs Engine - To STOP the engine, pull the
ENGINE SPEED CONTROL on engine rearward into
STOP position. Turn FUEL VALVE to OFF position.
Step 6: Honda Engine - To STOP the ENGINE move
the ENGINE KILL SWITCH to the OFF position. Move
FUEL VALVE rearward to OFF position.
2.5 HANDLE BAR ADJUSTMENT
Remove retaining screw and nut from handle bar
bracket. Adjust handle bar “UP” or “DOWN” as required.
Reinstall screw and nut. See Figure 7.
FIGURE 7
LOW
MEDIUM
HIGH
REMOVE
SCREW TO
ADJUST
HANDLEBAR
HANDLE
BRACKET
FUEL
VALVE
MOVE ENGINE SPEED
TO THE FAST POSITION
MOVE FUEL VALVE TO ON POSITION
MOVE ENGINE SPEED
CONTROL TO FAST
POSITION