Filter
Top Products
5
3 unit assembly
Note: Please refer to Parts List for correct part identification and placement.
FRONT WHEEL ASSEMBL
Y
• Place Mounting Bracket against lower right corner of
Blower Housing, aligning holes in bracket with threaded
holes in housing. Secure with three 3/8-16 x 1 hex
bolts, split lock washers and flat washers. Tighten
securely.
• Install Front Wheel between forks in bracket, slide
sleeve through bracket and wheel, and secure with 1/2-
13 x 5” hex bolt and lock nut. Tighten snugly while
allowing for free rotation of wheel.
HANDLE ASSEMBLY
• The upper handles are shipped in the folded storage
position. To unfold, loosen two handle knobs and rotate
up to the operating position. The upper handles are
secured with four knobs. Insert two 5/16-18 x 2 curved
head bolts through the handles directly below the two
shipping knobs. Place one internal tooth lock washer on
each of the bolts. Thread knobs onto curved head bolts.
Tighten all four knobs securely.
Assembly complete. Your unit is now ready to be started and checked for proper operation.
Some minor final adjustments may be required; see the Maintenance portion of this manual.