Filter
Top Products
11
• THROTTLE CABLE ADJUSTMENT: Correct cable
adjustment allows for full range of movement of throttle
body on engine in conjunction with throttle control on
handle. To adjust, loosen cable clip screw on engine,
then slide cable housing in or out in approximately 1/8-
1/4” increments. Retighten screw, recheck, and read-
just as needed.
• FRONT WHEEL CAMBER ADJUSTMENT: Correct
camber adjustment will place the front axle at 0
degrees, or parallel with level ground, and the wheel at
90 degrees or perpendicular with level ground. Adjust
by loosening the three mounting bolts and placing a
square aside the wheel and adjusting until square sits
flat on ground and touches upper and lower points of
tire, then retightening bolts. An alternate method is to
place a level against the side of the caster bracket.
LOOSEN SCREW
5 maintenance (cont.)
BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG
WIRE TO PREVENT INADVERTENT STARTING OF UNIT.
!
ADJUSTMENTS:
REPLACEMENT PARTS:
•
Replacement parts are available through your dealer
.
MOVE CABLE
90
O
0
O