Filter
Top Products
17
Section 4 - MAINTENANCE
WARNING
Allow engine to cool for at least ten minutes before
performing service or maintenance. DO NOT smoke
near fuel components when performing service or
maintenance. DO NOT perform service and
maintenance near an open flame. Wipe off any
spilled fuel before starting engine. DO NOT run
engine indoors.
4.5 ANNUALLY (END OF EACH SEASON)
(Continued from previous Page)
4.5.2. FUEL FILTER
Service fuel filter as instructed below. Turn key to
“OFF” position. Engine MUST be stopped and
MUST be cold before removing filter. Clamp fuel line
to prevent fuel spillage or perform filter change when
fuel tank and fuel line are empty.
1. Remove fuel line clamps from fuel filter.
2. Remove fuel lines from filter. Discard filter.
3. Install new fuel filter. IMPORTANT: Some fuel
filters are fuel flow directional. Check for arrow that
shows fuel flow direction. Reinstall fuel line clamps.
See Figure 4.8.
FIGURE 4.8
4.6 DECK REMOVAL
Move power unit/mower deck to an area where the
mower deck is to be disconnected. Turn engine
“OFF” and remove key from switch. Remove spark
plug wire(s) and secure away from spark plug(s).
Move motion control levers to the neutral lock
position. Engage parking brake.
1. Move deck lift lever and set the mower deck to
the highest cutting position. See Figure 4.9.
2. Place a wooden block under the front and rear
edge of the mower deck.
3. Move deck lift lever and set the mower deck to a
lower cutting position until deck rests on wooden
blocks. Position the deck to where there is no
tension on the deck hanger chains. See Figure 4.9.
FIGURE 4.9
(Continued On Next Page)
REMOVE LINE
CLAMPS
REMOVE
FUEL FILTER
POSITION DECK LIFT LEVER IN HIGHEST CUTTING
POSITION. PLACE WOODEN BLOCKS UNDER FRONT
AND REAR OF DECK. LOWER DECK ONTO BLOCKS
CLAMP FUEL LINE
TO PREVENT
SPILLAGE
HIGHEST
CUTTING
POSITION
LEFT SIDE OF
MACHINE
CLAMP FUEL
LINE TO
PREVENT
SPILLAGE
LOWEST
CUTTING
POSITION