Filter
Top Products
2.6 HANDLE HEIGHT ADJUSTMENT
NOTE: A 1/2” wrench will be needed to adjust
handle height.
1. The height of the handle can be adjusted by
loosening the four nuts located on the lower
handle brackets and pivoting the handle up or
down. Tighten all nuts securely. This provides
2 inches of adjustment. See Figure 14.
FIGURE 14
2.7 RECYCLING COVER
REMOVAL/INSTALLATION
1. The recycling cover is fastened in place using
two knobs. To remove the cover simply
unscrew the two knobs and lift off the cover.
See Figure 15. Note: When reinstalling the
cover, the deck side wall should fit between
the tab and outside of cover. Tighten knobs
securely. See Figure 16.
FIGURE 15
FIGURE 16
CAUTION
DO NOT operate mower without side chute,
recycling cover or adapter with grass bag in place.
2.8 SIDE DISCHARGE CHUTE
REMOVAL/INSTALLATION
1. The side chute is fastened in place using the
same two knobs used to secure the recycling
cover. There is also a carriage bolt and nut
(Found in hardware bag) that secures the
lower rear portion of chute. Use this bolt and
nut on the side chute only. Tighten all bolts, nuts,
knobs securely. See Figure 15 & Figure 16.
2.9 RECYCLING MOWER OPERATION
Use the following steps for the best results when
recycling.
1. Set the cutting height in the highest blade
setting. Refer to Section 2.5 CUTTING
HEIGHT ADJUSTMENT
2. Mow with the engine throttle lever set at the
fastest speed setting.
3. Push the mower at a slow ground speed to
allow fine chopping of the clippings or leaves.
NOTE: The grass must be dry. If the grass is
extremely dense, set the rear height adjusters
one notch lower than the front adjusters to
lower the rear of the deck. Experiment with the
deck settings to achieve best recycling.