Snapper 82354, 82355 Lawn Mower User Manual


 
SET UP INSTRUCTIONS
Thank you for purchasing a Lady Garden walk behind
lawn mower. With proper care and servicing this product
will give you many years of service. This product is
completely assembled and requires just a few minutes of
your time to prepare it for operation. Please perform the
following steps.
1. Open the carton by pulling on one of the two pull
tabs located toward the bottom of the carton. Pull tab
all the way around the carton.
2. Lift the top portion of the carton over the mower.
1) Remove the four corner posts. 2) Remove
protective wrapping on the bail. Remove cardboard
from between the handle and lower brackets.
3. Remove the container of oil located in the carton
inner pack at the rear of the mower.
4. Lift the cardboard tab from between the deck and
trailing shield.
5. Loosen the handle T-knobs and raise the handle to
the operating position. Retighten the T-knobs. See
Figure 2.
FIGURE 2
6. Move all four wheels to the highest height of cut (See
Section 2.5 - CUTTING HEIGHT ADJUST-MENT
SECTION)
7. Using the handle push the unit out of the carton
lower section.
CAUTION
The cutting blade has sharp edges which can cause
severe injury. Always wear heavy leather gloves
when handling blade to prevent injury.
8. With the aid of another person tip the mower back
until the handle touches the ground. Hold in that
position and carefully remove the foam block under
the deck. Return the mower to the upright position.
9. Pull the bail down to the handle, grasp the recoil T-
handle located at the engine recoil, and pull the rope
back and route it thru the rope guide located at the
right hand side of the handle. See Figure 3.
FIGURE 3
10. Remove the oil fill dipstick See Figure 4.
FIGURE 4