Filter
Top Products
Page 12
SHUTTING DOWN
Operation
TILLING
1. Adjust the depth regulator lever to desired tilling
depth.
NOTE: Raise depth regulator lever up one hole at a
time, testing tiller operation after each raise.
Raising depth regulator lever too high can result in
loss of control of tiller!
2. Move the throttle control to
fast
.
3. Place the tiller in
forward
by pushing down on the
drive safety control levers--this will engage the
wheels and tines.
NOTE: You can slow the tiller's forward advance at
any time by putting slight downward pressure on
the handlebars, or you can stop the tiller by
releasing the drive safety control levers to the
neutral position.
To stop wheels and tines at any time, release drive
safety control levers to neutral position.
Always release drive safety control levers to
neutral position before adjusting the depth
regulator lever.
Practice operating the controls and tiller with tines
out of ground before beginning to till. It is
important that you know how to use the tiller
properly, how to keep control at all times, how to
stop the tines and wheels from turning, and how
to stop the engine if necessary. If you do not know
how to do these things, read the Controls,
Adjustments and Safety sections before
proceeding.
Temperature of muffler and near by areas may
exceed 150
°°
°°
° F. Avoid these areas.
Do not move choke control to CHOKE to stop
engine. Backfire or engine damage may occur.
To stop the engine at any time, move throttle
control to the off position. To stop wheels and
tines at any time, release drive safety control
levers to neutral position.
WARNING
WARNING
Engine and surrounding parts become extremely
hot during normal use, and will cause serious burn
injuries if touched before the engine has cooled.
Allow engine to cool completely before
touching these hot surfaces.
DANGER
WARNING
WARNING
WARNING