Filter
Top Products
STEP 8: Bag Installation. Insert both grass bags onto
frame. Make sure the grass bag frame notches fit into
the frame recesses. See Figure 8.
FIGURE 8
STEP 9: Bag Installation. Lower cover assembly onto
frame. Lift up hook and insert it into hole in cover plate.
See Figure 9
3
FIGURE 9
STEP 10: Grass Tube Installation
Slide upper end of grass tube into opening of cover/frame
structure. Slide lower end of grass tube over adapter end
and rotate tube towards mower to secure handle hook
under latch. See Figure 10.
FIGURE 10
STEP 11: WEIGHT PLATE INSTALLATION (REAR
ENGINE RIDER ONLY)
IMPORTANT: Some model Riders may require the two
mounting holes to be drilled in the front frame. Refer to
Step 12 for drilling instructions. The mounting holes in
other models may be covered by the SNAPPER label.
Attach the nine (9) weights to the front frame using 3/8-16
x 2-1/4” hex cap screws, flat washers, 3/8” split lock
washers and 3/8-16 hex nuts. Tighten nuts and bolts
securely. See Figure 11.
MOUNT 9 WEIGHTS USING
CAP SCREWS, FLAT
WAHSERS, LOCK WASHERS
AND NUTS
PLACE HEAVY
WASHER ON
BOLT
FIGURE 11