Snapper SS5201R Snow Blower User Manual


 
520 Single Stage Snowthrower
5/2005
4
Unboxing & Assembly
1. Using a utility knife, open the box and remove the
snowthrower.
2. Install the discharge chute on to the rotating ring
located on the auger housing. Secure with the three
5/16 inch carriage bolts, flat washers and nylok nuts
found in the parts bag (the bolt heads go to inside
of of the rotating ring, with washers and nuts on the
outside). Refer to Figure 1.
NOTE: Install the rear bolt first for easier alignment.
3. Tighten bolts securely with a wrench.
4. Lift up folding handle to align it with lower handle
and tighten the wing knobs securely as shown in
Figures 2 and 3.
5 Mount clean-out tool in storage position on handle.
Refer to Figure 2.
IMPORTANT NOTE
When removing the snowthrower
from the box and unfolding the han-
dle bars DO NOT PINCH THE AUGER
CONTROL CABLE IN THE HANDLE
BARS.
Figure 1. Assembly of Discharge Chute
A. Discharge Chute D. Nuts
B. Carriage Bolts E. Rotating Ring
C. Washers
A
B
C
D
E
Figure 2. Handles and Clean-out Tool
A. Handle B. Wing Knobs C. Clean-out Tool
A
B
Figure 3. Lift Handles and Lock Wing Knobs
C