Snapper SS5201R Snow Blower User Manual


 
Quick Setup List -
520 Single Stage Snowthrower
5/2005
3
Page Setup Procedure Steps to Perform
4 Unbox & Assemble Remove Unit From Box.
Install Discharge Chute
Assemble Handle Bars
(Be careful not to pinch the auger cable)
Mount Clean-Out Tool in storage position
on handle
5 Fill Gas Tank Fill Gas Tank
6 Lubricate Snowthrower Lubricate all grease & oil points
7 Test Run Check Primer
Check Choke
Check Recoil Starter
Check Electric Starter (Where Applicable)
Check Auger Control Cable
Check Kill Switch
Check Chute Rotator
Check Deflector
Additional information concerning functional
tests, general adjustment procedures, and
the location of normal lubrication points are
included in these instructions.
Although all required lubrication and normal adjust-
ments on factory-assembled components are done at
the factory, this additional information is provided to
assist you in ensuring that each unit is delivered to the
customer in proper working order.