Snapper 5201M Snow Blower User Manual


 
FUEL TO OIL MIXTURE CHART (50:1)
U.S. Imperial Metric
Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil
Gallons Ounces Gallons Ounces Liters Milliliters
1 2.5 1 2.8 4 80 ml
2 5 2 5.6 8 160 ml
5 13 5 14.1 20 400 ml
520 Single Stage Snowthrower
5/2005
5
Fill Gas Tank
Fuel and Oil Mixture
The snowthrower uses a two cycle engine that requires
a mixture of fuel (gasoline) and oil for lubrication of
engine bearings and other moving parts.
The correct fuel/oil mixture ratio for the five horsepow-
er engine is 50 to 1. Use fuel/oil mixture chart shown.
NOTE: To prevent damage to engine, carefully
observe recommended fuel to oil mixing ratio and
procedures.
Gasoline and oil must be premixed in a clean fuel
container.
Always use fresh, unleaded, winter grade fuel
Never put plain, unmixed fuel into fuel tank. Shake
fuel container each time before filling fuel tank.
Never use “stale” fuel left over from last season or
stored for long periods.
DO NOT USE MULTI VISCOSITY OILS, SUCH AS
10W-30 or 10W-40.
Proper Fuel Mixing Procedure
1. Fill approved clean fuel container one quarter full
with fresh unleaded fuel - one quart (one liter) in a
one gallon (4 liter) container.
2. Pour recommended amount of high quality two
cycle oil — 2.5 ounces (80 ml) into fuel container
for one gallon (4 liters) of fuel. (NOTE: DO NOT
USE MULTI VISCOSITY OILS, SUCH AS 10W-30
or 10W-40.)
3. Reinstall cap on the fuel container and shake con-
tainer vigorously so oil mixes with gasoline.
4. Unscrew cap and fill container with fuel. Shake
container again.
5. Remove fuel tank cap and carefully pour mixed fuel
into the fuel tank, filling to 1/2 inch (1.5 cm) below
filler neck to allow room for expansion. Never put
plain, unmixed fuel into fuel tank. Shake fuel
container each time before filling fuel tank.
WARNING
Gasoline is highly flammable and must be handled
with care. Never fill the tank when the engine is hot
or running. Always move outdoors to fill the tank.
Keep snowthrower and gasoline away from open
flame or spark.
Figure 4. Proper Fuel Mixing Procedure
A. Fill Container with 1 Quart (1 Liter) of fuel
B. 2.5 Ounces (80 ml) of two-cycle oil
C. Combine in container, then shake container
D. Additional fuel brings total to 1 Gallon (4 liters)
A
B DC