Filter
Top Products
MOWING IN REVERSE
If an operator chooses to mow in reverse, the RMO system can
be used. To use the Reverse Mowing Option (RMO) turn the
RMO key after the PTO is engaged. The L.E.D. light will illumi-
nate, and the operator can then mow in reverse. Each time the
PTO is disengaged the RMO needs to be reactivated if desired.
The key should be removed to restrict access to the RMO fea-
ture.
ATTACHMENT OPERATION IN
REVERSE
If an operator chooses to operate a PTO driven attachment in
reverse, the RMO system can be used. To use the Reverse
Mowing Option (RMO) turn the RMO key after the PTO is
engaged. The L.E.D. light will illuminate, and the operator can
then operate the attachment in reverse. Each time the PTO is
disengaged the RMO needs to be reactivated if desired. The
key should be removed to restrict access to the RMO feature.
PUSHING THE TRACTOR BY HAND
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release back approximately 2-
1/2” (6 cm) to lock into released position (Figure 2).
3. The tractor can now be pushed by hand.
13
DRIVING THE TRACTOR
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls and see the dash-
board display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see STARTING THE ENGINE).
5. Disengage the parking brake and release the brake
pedal.
6. Depress the forward ground speed control pedal to
travel forward. Release the pedal to stop. Note that
the further down the pedal is depressed the faster the
tractor will travel.
7. Stop the tractor by releasing the ground speed con-
trol pedals, setting the parking brake, and stopping
the engine (see STOPPING THE TRACTOR AND
ENGINE).
MOWING
1. Set the mower cutting height to the desired level and
set the gauge wheels to the appropriate position (if
equipped).
2. Engage the parking brake. Make sure the PTO
switch is disengaged.
3. Start the engine (see STARTING THE ENGINE).
4. Fully lower the mower using the attachment lift lever.
5. Set the throttle to FULL.
6. Engage the PTO (Mower Deck).
7. Begin mowing. When the “catcher full” alarm sounds,
turn off the PTO immediately to prevent discharge
tube plugging. Travel to the desired location and
empty the catcher.
8. When finished, shut off the PTO and raise the mower
using the attachment lift control lever.
9. Stop the engine (see STOPPING THE TRACTOR
AND ENGINE).
Operating the Tractor
Figure 2. Transmission Release Lever & Fuel Tank
A. Fuel Tank Cap.
B. Transmission Release Lever
B
A
3
3
DO NOT TOW TRACTOR
Towing the unit will cause transmission
damage. • Do not use another vehicle to
push or pull this unit. • Do not actuate the
transmission release valve lever while the
engine is running.
WARNING
Mowing in reverse can be hazardous to
bystanders. Tragic accidents can occur if the
operator is not alert to the presence of children.
Never activate RMO if children are present.
Children are often attracted to the unit and the
mowing activity.
WARNING
The engine will shut off if the reverse ground
speed pedal is depressed while the PTO is on and
the RMO has not been activated. The operator
should always turn the PTO off prior to driving
across on roads, paths or any area that maybe
used by other vehicles. Sudden loss of drive
could create a hazard.