Filter
Top Products
www.snapper.com6
Operation
Starting and Operation (Continued)
Engine and Blade (Kawasaki Engine)
1. Make sure the fuel valve (A, Figure 5) on the engine is
open.
2. Move the engine speed control past the fast (‘Rabbit’)
detent to the ‘Choke’ position.
3. Pull the blade control (A, Figure 4) against the handle.
4. Pull the rope start handle (B) to crank the engine.
5. After the engine starts, allow a brief warm-up until the
engine runs smooth before beginning mower operation.
NOTE:
To stop the engine (and blade), release the blade
control.
Propelling the Mower
1. Start the engine. Refer to the Section entitled “Starting
and Operation – Engine and Blade”.
2. Move the ground speed control (A, Figure 6) to the
desired speed position.
3. Squeeze the wheel drive control (B) against the handle
to engage the wheel drive and propel the mower
forward. Forward speed can be adjusted while the
mower is moving by changing the position of the
ground speed control.
Stopping
1. Stop forward motion of the mower by releasing the
wheel drive control.
2. Stop the engine and blade by releasing the blade
control.
Handle Height Adjustment
The height of the mower handle can be adjusted as follows:
1. Loosen the lower nuts (A, Figure 7) on each
lower handle.
2. Move the handle assembly (B) up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to maintain
the desired position.
Figure 7: Adjusting the handle height
WARNING
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
!
!
Figure 5: Fuel shut-off (Kawasaki engine only)
A
B
Figure 6: Mower drive controls
A
B
A
Operation (Continued)