Filter
Top Products
Normal Removal
11
A. Channel Assembly G. Tubes
B. Cover H. Boot
C. Pin I. Puck
D. Hitch J. Discharge Tube
E. Bag K. Wire Form
F. White Bar L. Seal
E
D
B
Figure 17. Normal Installation & Removal
C
L
A
G
Collector Removal
1. Disconnect the discharge tube (J, Figure 17) from
boot (H) by moving wire form (K) up and out from
metal puck (I). Remove discharge tube (J) from seal
(L).
2. Lift up cover (B) remove and empty bags (E).
3. Remove pin (C). Lift and remove channel assembly
(A) and cover (B) from hitch (D).
WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower
deflector MUST be properly installed in the down
position and retained by the spring latch.
F
4. Lift discharge deflector up (E, Figure 16).
5. Loosen wing nut (B).
6. Slide lower chute (A) off carriage bolt (D) and
deflector hinge rod (F).
J
H
K
I