Filter
Top Products
11
Initial Setup & Assembly
INITIAL SETUP & ASSEMBLY
NOTE: Some of the following setup procedures may
already be completed.
Assemble Blade
1. Place the blade on a flat surface.
2. Install the bar stops (A, Figure 9) using the two 5/16-
18 x 1 taptite screws (B).
3. See Figure 10. Insert threaded end of eyebolt (A)
through lug on blade, and screw on 5/16 nut (B) just
far enough so that it is flush with the end of the eye-
bolt.
4. Hook the springs (C) into the pivot frame (D). Using a
pliers, stretch the springs to hook the opposite ends
to the eyebolts (A).
5. Tighten the nut (B) on each eyebolt enough to expose
about 3/4" (19 mm) of thread.
6. Holding the first nut (B) with a wrench,add a second
nut (E) to each eyebolt, and tighten securely against
the first nut to act as a jam nut.
Figure 10. Tension Springs
A. Eyebolt D. Pivot Frame
B. Nut, 5/16 E. Nut, 5/16
C. Spring
Figure 9. Bar Stop
A. Bar Stops
B. Taptite Screws, 5/16-18 x 1