Filter
Top Products
Normal Removal &
Installation
10
A. Hitch Support Assembly J. Deflector
B. Cover K. Nut & Capscrew
C. Pin L. Mounting plate
D. Hair Pins M. Lower Chute Rod
E. Bag N. Lower Chute
F. Grass Bag Hanger O. Pin
G. Upper Tube P. Strap, Middle
H. Middle Tube Q. Ridge
I. Strap, Boot R. Ridge Cutout
E
Q
D
B
Normal Removal & Installation
Collector Installation
Note: See previous pages for more detailed installation
and operation instructions if necessary.
1. Mount the hitch support assembly (A, Figure 15) onto
rear tractor frame.
2. Attach cover (B) to support assembly using pins (C)
and hair pins(D).
3. Pivot cover (B) up. Install bags (E) by attaching
grass bag hanger (F) to support assembly (A).
Figure 15. Normal Installation & Removal
C
P
I
N
O
M
L
J
R
A
K
4. Lift discharge deflector (J) up. Insert lower chute rod
(M) into mounting plate (L). Pull strap (I) and secure
by placing hole closest to knob in strap completely
over locknut and capscrew (K).
5. Slide the upper tube (G) into cover (B) aligning ridge
(Q) with cutout (R) as shown.
6. Slide middle tube (H) into upper tube (G). Slide mid-
dle tube (H) over lower chute (N). Pull strap (P) and
place hole completely over pin (O).
F
G
H
D
C