Simplicity ZT2561 Lawn Mower User Manual


 
CHECKING / ADDING FUEL
To add fuel:
1. Remove the fuel cap (see A, Figure 2).
2. Fill the tank.
Do not overfill. Leave approximately 1of room in the
tank for fuel expansion. Refer to your engine manual
for specific fuel recommendations.
3. Install and hand tighten the fuel cap.
4. Repeat same process for opposite tank.
FUEL FILTER
The fuel filter is located in the fuel line between fuel shut
off valve and carburetor, near the fuel pump. If filter is
dirty or clogged, replace as follows:
1. Shut off the fuel valve.
2. Disconnect the negative battery cable.
3. Place a container below the filter to catch spilled fuel.
4. Using a pliers, open and slide hose clamps from fuel
filter.
5. Remove hoses from filter.
6. Install new filter in proper flow direction in fuel line.
7. Secure with hose clamps.
8. Reconnect the negative battery cable when finished.
OIL & FILTER CHANGE
Refer to engine owners manual.
CHECK / CHANGE AIR FILTER
Refer to engine owners manual.
REPLACE SPARK PLUG
Refer to engine owners manual.
CHECK HYDRAULIC OIL LEVEL
NOTE: Do not open the hydraulic reservoir unless oil is
being added.
1. Lift up the seat plate to gain access to the oil reser-
voir compartment.
2. Look at the hydraulic oil reservoir (A, Figure 11) and
observe the oil level. When cold, the oil level should
be approximately 1/2below the MAX. HOT OIL
LEVEL line. The oil level should never be above the
MAX. HOT OIL LEVEL line.
3. If necessary, remove the reservoir cap (B, Figure 11)
and add either Mobil 1, 15W-50 synthetic oil or
Castrol Syntec 5W-50 oil. DO
NOT use conventional
oils. Make sure area around the fill neck of the
reservoir is free of dust, dirt, or other debris.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the area.
Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or
white gas because engine/fuel system
damage could result.
Regular Maintenance
15
Figure 11. Checking Hydraulic Oil Level
A. Hydraulic Oil Reservoir
B. Reservoir Cap
B
A