Filter
Top Products
64
TP 400-2307-03-LW-S
Traction Drive Group
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
985638
Mounted inside of frame.
Mounted outside
of frame.
Grease I.D. teeth
and flange.
Be sure tie bar support is in place. Move axle to
left (as viewed from back) to take up end play.
Move set collar (Ref. 51) to right to remove end
play in pivot arm (Ref. 42). Torque set screw
(Ref. 45) to 10 - 14 ft-lbs.
Apply grease to
bearing areas.
Hook into hole of
frame top.
Flat side towards
bearing.
Mounted
outside of
frame.
Must pivot
freely.
Mount in
hole at
upper rear
corner of
frame.
Torque to
18 - 21 ft-lbs.
Assemble Ref. 42, 44 & 49
with no end play. Parts
must rotate freely.
Grease bearing
area of Ref. 62.
Apply anti-seize
compound to wheel hub
area of Ref. 40 & 62.
Mount to bracket in
frame weldment.
Mounted
outside of
frame.
Apply Loctite and
Torque to 55 - 60
in-lbs. when all parts
are against hub.
Torque to
10 - 14 ft-lbs.
Apply locktite,
torque to
8 - 10 ft-lbs.
Pack groove
with grease.
Hook end to
top left corner
slot of frame.
Lubricate with
5W 50 Synthetic oil.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
3
23
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
44
45
46
47
48
49
50
51
26
27
4
5
5
4
2
22
1
43
41
55
33
62
63
54
53
52
61
64
65
45
55
53
56
57
58
59
60
17
2
3
66
3
2
4
24
5
The above parts group applies to the following Mfg. Nos.:
1693652 860DLX, 8HP Manual Start
1693653 860DLX, 8HP Manual Start (Export)
1694241 860DLXE, 8HP Electric Start
1693654 970M, 9HP Manual Start
1693655 970M, 9HP Manual Start (Export)
1694243 970E, 9HP Electrical Start
1693656 1180M, 11HP Manual Start
1693657 1180M, 11HP Manual Start (Export)
1694244 1180E, 11HP Electrical Start
© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved.