Simplicity LX 2000, LX 2900 Snow Blower User Manual


 
20
Remote Deflector Control Template
Line Template Up
with Edge of
Plastic
Dashboard
Mark and Drill One
9/32” Hole
Mount Bracket and
align with Line
Mark and Drill One
9/32” Hole
MOUNTING REMOTE DEFLECTOR
CONTROL
NOTE: Read through instructions before beginning.
1. Open the hood.
2. Cut out the template and place it on the lower left cor-
ner of the dashboard as shown above.
3. Mark and drill one 9/32” hole using the template to
locate the holes.
4. Mount the remote deflector mounting bracket (E,
Figure 29) control to the dashboard using upper hole.
5. Align center of lower hole to dashed line on template
and mark. Remove the remote deflector mounting
bracket (E). Drill one 9/32” hole using the marked
location.
6. Mount the remote deflector mounting bracket (E) con-
trol to the dashboard. Secure using two 1/4-20 x 7/8”
capscrews (A) through the bracket (E) and dash-
board.
7. Secure with 1/4 x 1-1/4 flatwashers (B), lockwashers
(C), and nuts (D) on the BACKSIDE of the dash-
board.
DO NOT OVER-TORQUE. Over-torquing may
crack the dashboard.
Figure 29. Mount Control Bracket - Current Models
A. 1/4-20 x 7/8 Capscrews D. 1/4-20 Nuts
B. 1/4 x 1-1/4 Flatwashers E. Mounting Bracket
C. 1/4 Lockwashers
Figure 28. Template Location
A
B
C
D
E