Filter
Top Products
11.See Figure 23. Insert the deflector control handle (B)
into the mounting bracket (C).
Route the remote deflector control cable and spout
rotator motor wires through the cable guide (Figure
24).
Secure the handle (B, Figure 23) using a clevis pin
(A) and hair pin clip (D).
NOTE: If the mounting holes have not been drilled in the
dashboard see Drill Remote Deflector Control Mounting
Holes under INITIAL INSTALLATION.
12.Lubricate the snowthrower as shown in the
Maintenance section.
13.Perform all adjustments as shown in the Adjustments
section.
18
Snowthrower Installation
Figure 23. Install Remote Deflector Control
A. Clevis Pin
B. Deflector Control Handle
C. Mounting Bracket
D. Hair Pin Clip
A
B
C
D
Figure 24. Cable and Wire Routing
Remote Deflector Control