Filter
Top Products
2
Installation Instructions
Kit Part No. 5600079
5100777
Rev. 07/2006
TP 200-7302-00-CI-S
© Copyright 2006 Ferris Industries. All Rights Reserved.
8. Position from the bottom the new front end against
the frame as shown in Figure 5. Then slide toward
the rear of the machine until the c-channel of the
new front end rests over the front cross member that
was cut.
Figure 5. Install New Front end
7. Install the plastic end caps (B, Figure 4) in the ends
of the cut cross member (A) and the new front end
(C).
C
B
A
Figure 4. Install Plastic End Caps
A. Cut Cross Member
B. Plastic End Cap
C. New Front end