Filter
Top Products
Install the Discharge Chute
NOTE: Some models have the discharge chute already
installed.
Place discharge chute (1. M, Figure 5) over tabs on chute
ring (N) as shown.
Secure discharge chute with three carriage bolts (2. O) and
nuts (P).
Figure 5
Route Defl ector Cable & Clip (if included)
Figure 6
Figure 7
Figure 4
L
NOTE: If the chute rotation is slow or binding, loosen the
chute rotation screws (L, Figure 4) 1/4 turn.
M
N
O
P
P
P
3. Tighten hardware to 66 in-lbs (7.6 Nm).
4. Connect the wire harness (electric chute models only).
NOTE: Check all bolts and nuts in fl ange for tightness. Do not
overtighten.
Not for
Reproduction