Filter
Top Products
Handles and Controls Group - Channel
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
Linkage adjustment for traction and
auger drive with power boost: with
drive levers engaged, the bottom end of
lower rods (Ref. 40 & 66) should be flush
with bottom of springs (Ref. 39 & 68).
To engine
ground
Shift rod assembly
(Ref. 71) must pivot
freely on pivot blocks
(Ref. 21).
Torque to
19 - 29 ft-lbs.
Mount clutch cable
to cable support, see
Engine & Frame.
To engine
plug
To spout
motor
To headlight
See Auger Housing and
Chute Group - 38"
The holes in the frame for Ref. 51 are
slotted so the gear support (Ref. 45) can
be positioned to ensure the inside surface
of the gear support is tight against the
hub of the front gear (Ref. 50).
Mount bushings (Ref. 78)
with flange on inside of
brackets, 3 places.
Slot towards
rear of unit.
10
14
13
1
2
4
5
6
3
7
12
21
12
9
15
16
17
18
19
25
54
8
20
23
24
35
36
26
34
60
64
69
70
69
56
71
96
4
4
4
5
72
4
65
66
67
56
62
62
56
63
61
22
68
53
55
58
2727
57
56
11
34
33
29
30
31
32
45
38
37
40
41
39
42
50
49
48
44
47
42
46
43
39
39
52
51
44
39
28
12
59
987044
The above parts group applies to the following Mfg. Nos.:
2005
4
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694847 - 10560E
1694848 - 10560EX
1694849 - 11570E
1694850 - E11570
1694851 - 1380E
1694852 - E1380
1694872 - 1390E
1694915 - 1390EX
TP 400-4250-00-LW-S