Filter
Top Products
Operation
OPERATING ON A SLOPE
While it is not recommended, traveling up and down
slopes may be required from time to time. These guide
lines are listed for your safety.
Traveling Up a Slope
Since the hill climbing ability of the machine will probably
far exceed any other machine you may have operated,
caution should be observed.
• Never make abrupt speed or direction changes on a
slope.
• Never push down on the handle bars while going up
a grade. A slight lifting pressure is recommended to
keep the front wheels on the ground.
Traveling Down a Slope
A very slow ground speed should always be used when
traveling down a slope. This can be accomplished by
GENTLY moving the ground speed control levers
towards the reverse direction.
MOWING
• Make sure the PTO switch is disengaged.
• Start the engine (see STARTING THE ENGINE).
• Set the throttle control to FULL.
•
Manual Start:
Grasp the operator presence /
parking brake handles and the handle bar grips at
the same time to deactivate engine kill system and
disengage the parking brake.
•
Electric Start:
S/N: 2013136020 & Below: Push down on either
one of the speed control handles to deactivate
engine kill system. Push the brake lever forward to
disengage the parking brake.
S/N: 2013136021 & Above: Push down on both of
the engine kill / operator presence handles to
deactivate the engine kill system. Push the brake
lever forward the disengage the parking brake.
• Engage the PTO by pulling up on the PTO switch.
• Begin mowing. See Lawn Care Section in the back
of this manual for tips on mowing patterns, lawn
care, and trouble shooting information.
• When finished, disengage the PTO.
• Stop the engine (see STOPPING THE MOWER).
PUSHING THE MOWER BY HAND
• Disengage the PTO, turn the ignition OFF, and
remove the key.
• Slide the hydraulic release rod forward and lock into
the top of the “T” slot. See Figure 2.
•
Manual Start:
Grasp the operator presence /
parking brake handles and the handle bar grips at
the same time to disengage the parking brake.
•
Electric Start::
Disengage the parking brake.
The mower can now be pushed by hand.
• After moving the mower, re-engage the transmission
(DRIVE position) by releasing the rod from the “T”
and sliding the release handle towards the rear of
the machine.
DO NOT TOW MOWER
Towing the unit will cause hydraulic
transmission damage. Do not use another
vehicle to push or pull this unit.
Figure 2. Hydraulic Release Rod
NEUTRAL POSITION
“DISENGAGE”
DRIVE POSITION
“ENGAGE”
STOPPING THE MOWER
• Returning the ground speed control levers to the
neutral position will stop movement.
• Disengage the PTO.
•
Manual Start
Release the operator presence /
parking brake handles to engage the parking brake.
•
Electric Start:
Engage the parking brake.
• Move the throttle control to mid-throttle position and
turn the ignition key to OFF. Remove the key.
DRIVING THE MOWER
• Make sure the PTO switch is disengaged.
• Start the engine (see STARTING THE ENGINE).
• Set the throttle control to FULL.
•
Manual Start:
Grasp the operator presence /
parking brake handles and the handle bar grips at
the same time to deactivate engine kill system and
disengage the parking brake.
•
Electric Start:
S/N: 2013136020 & Below: Push down on either
one of the speed control handles to deactivate
engine kill system. Push the brake lever forward to
disengage the parking brake.
S/N: 2013136021 & Above: Push down on both of
the engine kill / operator presence handles to
deactivate the engine kill system. Push the brake
lever forward the disengage the parking brake.
• With your thumbs, pressing the ground speed control
levers forward will move the mower forward. Pulling
them back will move the mower backwards. The
farther the levers are pushed or pulled will result in a
faster ground speed.
• To slow the mower, gently release your thumb
pressure on the ground speed control levers to return
them to the neutral position.
49320
13
Not for
Reproduction