Filter
Top Products
17
Maintenance
SCHEDULE
CHECK AUGER
GEAR CASE LUBRICATION
1. Place the snowthrower on a level surface.
2. Remove the fill plug (Figure 12).
3. Check the lubricant level. It should be level with the
lower edge of the plug opening. If not, add Simplicity
Winter Weight Worm Gear Oil (available from your
dealer).
4. Re-install fill plug, and tighten securely.
Figure 12. Checking Auger Gear Case Lubrication
Check auger gear case lubrication.**
Lubricate snowthrower.
Check tire pressure.
Change engine oil.*
✛
Clean or replace spark plug.
✛
Check drive linkage/belt tension
Lubricate Axle Shafts
25 Hours
10 Hours
Monthly
50 Hours
✛
Yearly
4-6 Hours
Yearly
Simplicity Winter Weight
Worm Gear Oil
10W Oil and Grease
N/A
See Engine Manual
See Engine Manual
N/A
Lithium Grease
CARE REQUIRED FREQUENCY LUBRICATION
* Change original oil after two hours of operation.
**Check oil level each fall and spring.
✛ See your engine Owner’s Manual.
Fill Plug
CHECKING TIRE PRESSURE
The air pressure in each tire should be 20 psi (136 kPa)
and should be equal for both tires for best performance.
Be sure to keep caps on valves to prevent entry of debris
into the valve stem when tires are filled.
Figure 11. Checking Tire Pressure