Filter
Top Products
16
Operation
Figure 9. Traction Drive Lock - Disengaged
FREE-WHEELING AND
TRACTION DRIVE LOCK
For easy turning when pushing the snowthrower, you
can disengage the traction drive at one or both wheels
by using the Traction Lock Pins (See Figures 9 & 10).
1. Turn the unit off, remove the Engine Key, and discon-
nect the spark plug wire.
2. To DISENGAGE the traction drive lock, insert the
Traction Lock Pin through the outer hole in the axle.
(See Figure 9).
3. To ENGAGE the traction drive lock, insert the pin
through the hub and axle (See Figure 10). If the hole
in the hub is not aligned with the inner hole in the
axle, push the snowthrower until the holes align and
install the Traction Lock Pin.
NOTE: For best drive performance engage both wheels.
For easier turning disengage one wheel.
Figure 10. Traction Drive Lock - Engaged
AFTER EACH USE
Normal use of the snowthrower may result in a build-up
of packed snow in and around the starter cord housing
and around engine controls.
Heat from the engine will
usually prevent the snow from freezing solid while the
unit is running, but after the engine is shut down, some
snow may continue melting from engine heat, and later
freeze around some moving parts as the unit cools.
After each period of use, follow these steps
to prevent
freeze-up caused by ice formation
in and around the
engine controls and external parts.
1. Before shutting off the engine, pull the starter rope
out 2 - 3 times, and allow it to rewind slowly. This will
help clear packed snow from the starter cord area.
Run engine a few minutes before shutting off.
2. Stop the engine by moving the throttle lever (See
Figure 6) down, or by pulling out the engine key.
3. Disconnect the spark plug wire, and position it away
from the spark plug.
4. Brush snow and ice from the snowthrower. Be sure to
clear engine and snowthrower controls, discharge
chute, worm and chute rod gears, clutch rod areas,
and anywhere else snow has accumulated.
5. Always remove the engine key and store in a safe
place to prevent unauthorized use.
6. If the snowthrower is kept in a cold shelter, fill the fuel
tank to prevent condensation. Do not store near
sparks or flame.
NOTE: The Engine Owner’s Manual contains further
information on preventing ice formation and freeze-up.
Klik-Pin In
OUTER Hole
Klik-Pin In
INNER Hole
WARNING
Never store snowthrower, with gasoline in the
engine or fuel tank, in a heated shelter or in an
enclosed, poorly ventilated enclosure. Gasoline
fumes may reach an open flame, spark or pilot
light (such as a furnace, water heater, clothes
dryer, etc.) and cause an explosion.
Handle gasoline carefully. It is highly flammable
and careless use can result in serious fire
damage to people and property.
Drain fuel into an approved container outdoors
away from open flame or sparks.