Filter
Top Products
Trim Installation
Face Mask installation:
1.
Position the face mask onto
the unit with the hook in the
middle grille slot, and line
up with the holes on the
outside of the side panels
(note that the front of the
face mask must be in the
“V” position for proper fit.)
2.
Insert one Carriage Bolt
through each of the two
mounting holes at the rear
of the face mask, and into
the side panels.
3.
Place one washer onto
each Carriage Bolt from the
inside of the panel.
4.
Thread one Nut onto each
Carriage Bolt.
5.
Check that the Face Mask
is in the proper position and
orientation.
6.
Tighten the Nuts securely.
Hook from Face
Mask goes into
middle
gri//e
s/o’\
NOTE: “V” positioning
-I\\-
1
b
Carriage Bolt