Filter
Top Products
03
10
ENGINE SPEED
For overall best performance, run the snowthrower at full
engine operating speed. Use the engine Throttle Lever
(E, Figure 6) to set the engine speed. Slide the Throttle
Lever UP to increase engine speed, and DOWN to
reduce speed.
GROUND SPEED SELECTOR
Use the Speed Selector (A, Figure 7) to control the drive
speed of the snowthrower. There are five forward speeds
and two reverse speeds.
Use the lower speeds to blow deep or wet snow. Use the
higher speeds to blow light snow or to drive the snow-
thrower without blowing snow.
To change speeds, release both control levers (B, Figure
7), then move the Speed Selector to the desired setting.
Fully depress the control levers to resume.
DEFLECTOR
The distance of the discharged snow is mainly controlled
by the position of the deflector. (Engine speed also
affects distance of discharge.) The more the deflector is
tilted UP, the farther snow will be thrown.
Models with Chute Deflector Knob
1. Loosen the deflector knob, tilt the deflector UP or
DOWN.
2. Retighten the knob when desired angle has been
chosen.
Models with Remote Deflector Control
1. Turn the Remote Deflector Control counterclockwise
to UNLOCK, and the spring will pull the deflector to
the maximum throwing position. Pull the knob UP to
decrease the throwing distance.
2. Turn the Remote Deflector Control knob clockwise to
LOCK in place when the desired angle has been cho-
sen.
SCRAPER BAR & SKID SHOES
On smooth surfaces such as concrete or asphalt, the
scraper bar should scrape the surface. On surfaces such
as gravel, the scraper bar should be high enough so that
it will not pick up gravel or debris.
The height of the scraper bar is controlled by raising or
lowering the Skid Shoes (See Figure 10).
1. To raise the scraper bar height, rest the scraper bar on
a strip of wood equal in thickness to the desired height.
2. Make sure the scraper bar is parallel to the ground
surface.
3. Loosen the skid shoe nuts and let the skid shoes
drop to the surface.
Operation
Figure 10. Skid Shoe Adjustment
Scraper
Bar
Skid Shoe
Figure 8. Chute Deflector Adjustment (Some Models)
Chute
Deflector Knob
Chute
Deflector
Skid Shoe
Nuts
Figure 9. Remote Deflector Control (Some Models)
Remote Deflector
Control
Muffler
Clip
Cable
Maximum Throw
Position
Control Cable
Spring
4. Tighten the nuts, making sure the Skid Shoes are
adjusted equally and are parallel to the surface.
5. To lower the height of the scraper bar, raise the Skid
Shoes.
6. If the scraper bar becomes worn, it can be replaced
by removing the hardware attaching it to the
snowthrower.