Filter
Top Products
15
RAISING THE SEAT DECK
To gain access to the engine compartment, simply raise
the seat deck forward.
CHECKING/ADDING GASOLINE
Check the gas gauge/cap to be sure there is enough
gasoline to complete the job. To add gasoline, remove
the gas gauge/cap. Do not overfill. Leave room in the
tank for fuel expansion. Refer to your engine manual for
gasoline recommendations. Install and hand tighten the
gas gauge/cap.
CHECKING TIRE PRESSURE
Front and rear tire pressure should be 10 to12 psi (68 to
82 kPa)
CHECKING FUEL FILTER
The fuel filter is located in fuel line between fuel tank and
carburetor. If filter is dirty or clogged, replace as follows.
Place a container below filter to catch spilled gasoline.
1. Using a pliers, open and slide hose clamps from fuel
filter.
2. Remove hoses from filter.
3. Install new filter in proper flow direction in fuel line.
Secure with hose clamps. See warning at beginning
of procedure.
Normal Care
See Before Before Every Every 25 Every 100 Spring
Safety Items Page First Use Each Use 5 Hours Hours Hours & Fall
Check safety interlock system. 8 ● ●
Check rider brakes. 26 ● ●
Check mower blade stopping time. 30 ●●
Normal Care Items
Check rider & mower for loose hardware. – ●● ●
Check engine oil level. * ●● ● ●
Check engine & air filter. * ***●
Change engine oil and filter.** * ***Every 50 hrs. ***●
Lubricate rider & mower. 17 ***●
Check fluid levels & tire pressure 16 ●● **●
Change transmission fluid.
(Hydro only)****
– Only if transaxle is serviced.
Check fuel filter. 16 ●
Clean battery & cables 18 ●
Clean/sharpen blades. 18 ●
Inspect spark plug(s). * ●
* See the engine manufacturer's owner's manual.
** Change original engine oil after first 5 hours of operation.
*** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
**** Transaxle is a sealed unit and requires no regular interval fluid changes.
SCHEDULE
The following schedule should be followed for normal care of your rider and mower. You will need to keep a record of
your operating time. Determining operating time is easily accomplished by multiplying the time it takes to do one job
by the number of times you’ve done the job, or you can install the optional hour meter.
CAUTION
Never use gasoline containing METHANOL, gaso-
hol containing more than 10% ethanol, gasoline
additives, premium gasoline, or white gas because
engine/fuel system damage could result.
WARNING
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.