Filter
Top Products
9
Operation
GENERAL
Before operating this rider for the first time, the owner
should operate in an open area without mowing, to
become accustomed to the unit. The left side of the
mower can be used to trim close to objects. Be sure to
read all information in the Safety and Operation sections
before attempting to operate this rider and mower.
MOWER REMOVAL AND INSTALLATION
WARNING
Never allow passengers to ride on the unit.
WARNING
To reduce fire hazard, keep the engine and
mower free of grass, leaves and excess grease.
WARNING
Stop engine and remove key. Do not engage PTO
until mower is completely removed or installed
and operator is seated.
WARNING
The interlock safety switches are for your safety.
Do not attempt to bypass them.
WARNING
Towing the rider will cause transmission dam-
age. Do not use another vehicle to push or pull
rider .
Figure 5. Mower Removal/Installation (34” mower shown)
A. Idler Pulley Arm D. Lift Cable
B. Idler Pulley E. Lift Hook
C. PTO (Electric Clutch) Pulley F. Rear Trailing Arms
*2396
WARNING - SLOPE OPERATION
Never operate on slopes greater than 30 percent
(16.7°) which is a rise of three feet vertically in 10 feet
horizontally. When operating on slopes that are
greater than 15 percent (8.5°) but less than 30 percent
use front counterweights and rear wheel weights (see
your dealer). Select slow ground speed before driving
onto slope. In addition to front and rear weights, use
extra caution when operating on slopes with rear-
mounted grass catcher. Mow UP and DOWN the slope,
never across the face, use caution when changing
directions and DO NOT START OR STOP ON SLOPE.
NOTE: Perform mower installation on a hard, level sur-
face such as a concrete floor. For easier mower removal
and installation, rear trailing arms (F, figure 5) can be
removed by removing spring clips and clevis pins.
1. Park rider and turn off PTO switch and engine,
remove the key and apply parking brake. Turn the
wheels fully to the left.