Filter
Top Products
Handles and Controls Group - 1060, 1170, 1280 & 1390 Models
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
Linkage adjustment for traction and
auger drive with power boost: with
drive levers engaged, the bottom end of
lower rods (Ref. 40 & 66) should be flush
with bottom of springs (Ref. 39 & 68).
To engine
ground
Shift rod assembly
(Ref. 71) must pivot
freely on pivot blocks
(Ref. 21).
Torque to
19 - 29 ft-lbs.
Mount clutch cable
to cable support, see
Engine & Frame.
To engine
plug
To spout
motor
To headlight
See Auger Housing and
Chute Group - 38"
The holes in the frame for Ref. 51 are
slotted so the gear support (Ref. 45) can
be positioned to ensure the inside surface
of the gear support is tight against the
hub of the front gear (Ref. 50).
Mount bushings (Ref. 78)
with flange on inside of
brackets, 3 places.
Slot towards
rear of unit.
10
14
13
1
2
4
78
5
6
3
7
12
21
12
9
15
16
17
18
19
25
57
8
20
23
24
35
36
37
38
39
40
26
34
4
66
63
38
37
69
74
75
74
59
76
4
82
80
81
79
96
4
4
5
77
4
70
71
72
59
65
65
59
68
36
67
64
22
73
56
58
61
2727
60
59
11
34
33
29
30
31
32
83
42
41
44
45
43
46
53
50
49
48
52
46
51
47
43
43
55
54
48
43
28
12
62
84
986724
The above parts group applies to the following Mfg. Nos.:
2005
6
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694590 - 1060E
1694591 - 1170E
1694592 - 1280E
1694593 - 1390E
1694598 - 1060M
1694599 - 1170M
1694600 - 1280M
1694601 - 1390M
TP 400-4155-01-LW-S